How do I reset my sump pump alarm?

03/25/2019 Off By admin

How do I reset my sump pump alarm?

How to Reset a Sump Pump

  1. Locate the reset button on the motor. If there isn’t one, locate the on/off switch and turn it off, or unplug the pump directly from the electrical outlet.
  2. Look inside of the sump pump.
  3. Plug the pump back in or move the switch back to the on position if there was no reset button.

What does sump pump alarm do?

An alert alarm monitors water levels in your sump pump. Your sump pump is typically out of sight but works in high-risk areas where overflows can cause excessive damage. To let you know something is wrong with your sump pump, the system often sets off an audible alarm.

Why is my pump alarm going off?

An alarm system gives you a warning when the water level in the pump tank is rising more than it should be or are the levels are too low. If, for some reason, there is a lot of water being introduced into the system between the pumping cycles, the water has no place to go except into the pump tank.

Why does my back up sump pump keep beeping?

If there is a power outage, your battery backup sump pump will start to beep. This noise is to acknowledge that the backup battery sump pump is in operation. Pumps typically only run for a third of the time. In most cases, you’ll have 24 hours of protection until the power comes back on.

How do I silence my basement watchdog alarm?

To permanently disable the water fluid low alarm, attached the fluid sensor rod to the positive terminal of the battery. This can be done by tightening down the wing nut on top of the positive terminal and the fluid sensor.

What causes a sump pump to not shut off?

Other Reasons Your Sump Pump Won’t Turn Off The sump pump check valve could be defective. Your sump pump could be too small, or the pit could be too large. There could also be a sewer leak under your house, or your sump pump could be poorly located in a location just below the water table.

Does sump pump have an alarm?

Sump pumps can have two kinds of alarms: a high-water alarm and a low-water alarm. First, you’ll need to know if your system has a high-water alarm. If it does, and that’s the alarm going off, you’re in good shape. The high-water alarm is designed to be an early-warning system.

What do you do when your sewer alarm goes off?

If the alarm happens to be going off, the best thing to do is to push the red button or switch on the alarm box. This will turn off the alarm. There should be a red light and a green light located somewhere on the alarm box. The green light means that the alarm has power and should always be on.

How long do sump pump battery backups last?

As a general rule of thumb, during a power outage most new fully-charged batteries will last roughly 5-7 hours of continuous pumping and roughly 1-3 days of non-continuous pumping depending on the frequency.

How many years does a watchdog battery last?

A: The battery lasts anywhere from 3 to 5 years or so. The pump should last longer. You test it regularly and I would think about replacing from time to time, just for peace of mind.

Does the Basement Watchdog charge the battery?

Use the Basement Watchdog control unit for charging a LEAD-ACID battery only. DO NOT use the control unit for charging dry-cell batteries that are most commonly used with home appliances. ALWAYS remove the charger from the electrical outlet before connecting or disconnecting the battery cables.