How do I setup my rocket M2 as an access point?
How do I setup my rocket M2 as an access point?
Steps to configure UBNT Rocket M2 as Access Point Mode
- Open the browser in your system or laptop and type the IP address of the UBNT Rocket M2 router.
- And then hit the enter button.
- Then you have to enter the default username and password.
What is a nano station M2?
The Ubiquiti NanoStation M2 provides a secondary ethernet port with software enabled POE output for seamless IP Video integration. Intelligent PoE. Remote hardware reset circuitry of Ubiquiti NanoStation M2 allows for device to be reset remotely from power supply location.
How are Ubiquiti nsm2s deployed in bridge mode?
I have deployed two Ubiquiti NSM2s both in bridge mode. Under the wireless tab, I have the mode set to AP-REPEATER and the WDS Peers set to the MAC addresses of each other. Under Network, I have set the Management interface to static IPs in the same LAN. I did it static because my network runs static.
What is the default IP address for nanostation-2?
• Since the default Nano IP address is in the very common range 192.168.1.x, and we cannot risk having the same range on our own local LAN as the WLAN ashore, we have changed the original Nano IP from 192.168.1.20 to 192.168.10.20.
Can a Nanostation be used as an AP repeater?
The Nanostation line is designed to be a Client or Client bridge device. They can be used as a AP, but I think its intended for point to point scenarios, not servicing end user devices. Was this post helpful? Thanks for your feedback!
Can a Nanostation be used as a router?
The Nanostation will act as a router which makes WIFI cruising much easier. (This refers to the WIFI side of the Nanostation) The Nano will automatically be assigned an IP address, gateway and DNS server by the WIFI access point you connect to later. (This refers to the local wired side = you)